(705) 324-1544Request service
Menu

Plumbing service · Kawartha Lakes

Well Pump and Pressure Tank Service

When a rural property loses water pressure, the well pump is usually the first component homeowners suspect. It is understandable because the pump is responsible for moving water from the well, but it is only one part of the system. A pressure tank, pressure switch, filters, check valves and the household plumbing all affect how water reaches the fixtures. Replacing the pump before understanding how the entire system is behaving can turn into an expensive guess. The pressure gauge, pump cycling pattern and condition of the tank can provide important clues about whether the problem actually starts with the pump.

Request Plumbing Service

How the Pressure System Works

The pressure tank stores water under pressure so that the pump does not need to start every time someone opens a faucet for a few seconds. As water is used and pressure falls, the switch tells the pump when to start. Once the system reaches the upper pressure setting, the pump turns off again.

If the tank is not functioning correctly, the pump may begin starting and stopping much more often than normal. That repeated cycling increases wear and can make the household pressure feel inconsistent.

Low Pressure Has Several Possible Causes

Weak pressure can result from a clogged filter or treatment device just as easily as from a problem with the pump itself. Valves, piping restrictions and pressure controls can also affect flow. That is why it helps to know whether pressure is weak throughout the property, whether the pump is cycling normally and whether the problem appeared suddenly.

Questions homeowners ask

Well Pumps & Pressure Tanks FAQs

Why does my well pump turn on every few seconds?

Rapid cycling commonly points to a pressure-system problem. The pressure tank, switch or another component should be checked rather than assuming the pump itself is the cause.

Does low pressure mean I need a new pump?

No. Filters, valves, pressure tanks, switches and treatment equipment can all cause weak pressure.

Why do I sometimes get air from the faucets?

Air can enter or move through a private water system for several reasons. The pattern and timing of the problem help determine where to begin looking.

Why is my pump running when nobody is using water?

The system may be losing pressure through a leak, check-valve issue or another fault. Continued pump operation without water use deserves investigation.

How do I know whether the pressure tank is failing?

Frequent pump cycling and unusual pressure changes can be signs, but the tank and pressure settings should be properly checked before replacement.

Pressure Dropping or Pump Cycling?

Tell us whether the problem affects the whole property, how often the pump is starting and whether you've lost water completely. Those clues can help separate a pump problem from a pressure-tank, control or plumbing issue.

Call (705) 324-1544Request Plumbing Service
Call Kawartha Plumbing